|
[Sponsors] |
Remeshing in Fluent 14.5 .. for an hexa mesh genrated from an Ogrid |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
Join Date: Jul 2012
Posts: 48
Rep Power: 14 ![]() |
My problems deals with the drag prediction on an air missile.I need to employ the Dynamic Mesh+6 D.O.F to account for the rolling motion of the missile.
I need to know whether Ansys FLUENT v14.5 is capable of remeshing ( Dynamic mesh) .. the O-grid generated initial Hexa mesh I'm new to ICEM CFD and investing a lot of time on learning Hexa meshing Blocking strategy .. though I'm short of time for my project.. If Ansys-Fluent isnt capable of remeshing the hexa mesh then I could directly use tetra mesh (easily generated) and it'll save me a lot of time..although the cell count is compartively very large than an hexa O-grid cell count. Plz help ![]() ![]() ![]() ![]() ![]() ![]() |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] export hexa mesh to fluent | Wieland | ANSYS Meshing & Geometry | 37 | January 23, 2013 03:27 |
Fluent reads mesh file well, but error when mesh checking | jyoung79 | FLUENT | 3 | November 13, 2012 05:50 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
prob while exporting icem cfd hexa mesh to fluent | mani | CFX | 4 | March 7, 2007 03:41 |