|
[Sponsors] |
August 26, 2013, 09:31 |
DPM injection every second in transient
|
#1 |
Senior Member
Astio Lamar
Join Date: May 2012
Location: Pipe
Posts: 186
Rep Power: 14 |
Hello everybody.
I want to release 10 particles form a point every second in transient calculation. But I don't know how it would be possible. Moreover, I need to release particles for a certain time, until the domain become in balance with released and exhaust particles. Then I need to count the amount of particles which are leaving the domain through the exhaust during five minutes. Any suggestion to this? How can I count the particles for a certain time (five minutes)? Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
injection problem | Mark New | FLUENT | 0 | August 4, 2013 02:30 |
Dpm injection mass flow rate | diamondx | FLUENT | 0 | November 22, 2012 14:04 |
DPM injection mass flow rate | kingpots | ANSYS | 0 | November 22, 2012 12:12 |
On DPM injection properties. | akr | FLUENT | 4 | October 23, 2006 11:54 |
DPM Injection Parameters | Hendawi | FLUENT | 0 | June 13, 2002 10:41 |