Fluent-gridgen axis abnormalities (screencap attached)

shookybal · August 3, 2013, 12:57

Hello,

I have created a 3D structured mesh in gridgen- a quarter of a nozzle (with periodic boundry conditions).
The believe the axis domains required for creating the blocks cause the problem.

I imported it to fluent and I get non-physical results near the axis

how can I solve this issue?

Thanks,
shookybal

shookybal · August 13, 2013, 15:36

I have created a new mesh using ICEM and got the same results.
The problem is in fluent..

What can I do?

flotus1 · August 13, 2013, 16:27

Did you review the boundary conditions in fluent to make sure everything is correct?

shookybal · August 14, 2013, 11:25

yes I did.

2 symmetry planes,
1 pressure inlet
1 pressure outlet

just a regular nozzle...

August 3, 2013, 12:57	Fluent-gridgen axis abnormalities (screencap attached)	#1
shookybal New Member shacharbala Join Date: May 2011 Posts: 11 Rep Power: 15	Hello, I have created a 3D structured mesh in gridgen- a quarter of a nozzle (with periodic boundry conditions). The believe the axis domains required for creating the blocks cause the problem. I imported it to fluent and I get non-physical results near the axis how can I solve this issue? Thanks, shookybal

August 13, 2013, 15:36	anyone?	#2
shookybal New Member shacharbala Join Date: May 2011 Posts: 11 Rep Power: 15	I have created a new mesh using ICEM and got the same results. The problem is in fluent.. What can I do?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Two questions on Fluent UDF	Steven	Fluent UDF and Scheme Programming	7	March 23, 2018 04:22
Different Results from Fluent 5.5 and Fluent 6.0	Rajeev Kumar Singh	FLUENT	6	December 19, 2010 12:33
axis change in fluent	Aly	FLUENT	2	August 20, 2005 18:15
Gridgen + Fluent 6.2	Sowjanya	FLUENT	2	July 20, 2005 14:35
FLUENT and GRIDGEN	YANG	FLUENT	1	April 9, 2003 05:53

August 13, 2013, 16:27		#3
flotus1 Super Moderator Alex Join Date: Jun 2012 Location: Germany Posts: 3,427 Rep Power: 49	Did you review the boundary conditions in fluent to make sure everything is correct?

August 14, 2013, 11:25		#4
shookybal New Member shacharbala Join Date: May 2011 Posts: 11 Rep Power: 15	yes I did. 2 symmetry planes, 1 pressure inlet 1 pressure outlet just a regular nozzle...