Change in Fluent 13.0 version

shubham208011 · July 15, 2013, 09:50

Hi..

I am using Fluent 13.0 version. I also had an experience of using Fluent 6.3 version.
I see a change in 13.0 version. In earlier version i.e. Fluent 6.3, the input required under velocity boundary condition are velocity magnitude and direction or velocity components etc. Nothing required for pressure.
But Fluent 13.0 also asked for supersonic/initial gauge pressure.

I am confused what value should I enter here..Fluent 13.0.jpg

Fluent 6.3.jpg

vasava · July 23, 2013, 02:30

The two pictures are for velocity inlet for laminar and turbulent models. And they are same in fluent 6 and fluent 13.

July 15, 2013, 09:50	Change in Fluent 13.0 version	#1
shubham208011 Member shubham Join Date: Mar 2009 Posts: 48 Rep Power: 17	Hi.. I am using Fluent 13.0 version. I also had an experience of using Fluent 6.3 version. I see a change in 13.0 version. In earlier version i.e. Fluent 6.3, the input required under velocity boundary condition are velocity magnitude and direction or velocity components etc. Nothing required for pressure. But Fluent 13.0 also asked for supersonic/initial gauge pressure. I am confused what value should I enter here..Fluent 13.0.jpg Fluent 6.3.jpg

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OpenFOAM-1.6 install cookbook	MadsR	OpenFOAM Installation	372	November 20, 2010 12:57
fluent version	jitendra	FLUENT	0	September 8, 2010 02:57
few quesions on ANSYS ICEMCFD and FLUENT	Prakash.Paudel	ANSYS	0	August 12, 2010 13:07
Can Fluent 32bit version run using 64bit CPU?	Danny	FLUENT	3	August 16, 2005 10:04
udf application in student version of fluent	arun	FLUENT	1	April 8, 2004 21:15

July 23, 2013, 02:30		#2
vasava Senior Member Paritosh Vasava Join Date: Oct 2012 Location: Lappeenranta, Finland Posts: 732 Rep Power: 23	The two pictures are for velocity inlet for laminar and turbulent models. And they are same in fluent 6 and fluent 13.