Cell Zone Size Question -- CFD Online Discussion Forums

July 2, 2013, 02:47	Cell Zone Size Question	#1
Maralady Member Arthur Loginow Join Date: Aug 2012 Posts: 99 Rep Power: 14	Hello, I am working with rotating geometries, and a doubt came to my mind, I was trying to search the answer at the forums or the FUG but was not able to find anything, when you create a cell zone (in this case a rotating cell zone), how big or how small this cell zone should be? I believe that theoretically should be as small as it can, big enough to barely cover the geometry that it is moving but I have not been able to find something to support this thought. Would like to know about your opinions and ideas about this. Thanks Last edited by Maralady; July 2, 2013 at 11:49.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[CGNS] CGNS converters available	mbeaudoin	OpenFOAM Meshing & Mesh Conversion	137	December 14, 2018 05:20
UDF for heat source on surface instead of the whole cell zone??	benson621	Fluent UDF and Scheme Programming	4	December 8, 2011 12:54
Segmentation Fault in fluent3DMeshToFoam	cwang5	OpenFOAM Bugs	23	April 13, 2011 16:37
Phase locked average in run time	panara	OpenFOAM	2	February 20, 2008 15:37
Stack frame size, Origin 2000, fortran, a question.	Sergei Chernyshenko	Main CFD Forum	4	February 22, 1999 15:24

All times are GMT -4. The time now is 17:09.