[FJSJ]

Hi guys,

I would like to do a complete model about wind turbine. I mean, I have 2 blade model but, in this moment, I´m running only 1 blade and MRF with periodic bc. So.. I would like to do the entire model and then simulate it. So..I´m not sure about how to do this. I mean, I can generate the entire mesh, but then... If I want to simulate the flow through the wind turbine and then make a video.. I don´t know how to do the setting.

If anybody can give me some advices I would be grateful.

Thank you.

[-mAx-]

Then you may use moving mesh, with sliding mesh:
stator + rotor, where both domains are disconnected
if you are using gambit, check here:
http://www.cfd-online.com/Forums/ans...tml#post432067