Cylinder heat flux -- CFD Online Discussion Forums

April 16, 2013, 07:45	Cylinder heat flux	#1
fluent87 New Member Cristiano Join Date: Feb 2013 Posts: 11 Rep Power: 13	Hi to Everybody! I did a Combustion Diesel Two Stoke Engine Simulation, following the Eddie Model Tutorial. In adibatic or isoentropic condition (heat flux and temperature boundary condition set 0). I obtain correct pressure and temperature values. Now I don't understand how to set heat flux or wall temperature in the model to obtain real value. If I set like 0 K on wall temperature in boundary condition I obtained good results, but I don't think that is correct. Somebody could help me?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Total heat transf. rate vs Total surface heat flux	Renato Sousa	FLUENT	1	April 14, 2020 04:27
Conjugate Heat Transfer: Wall Heat Flux at Coupled Walls?	MaxHeat	FLUENT	4	September 14, 2017 11:44
Calculating heat flux	hugo17	OpenFOAM Post-Processing	4	May 27, 2015 13:47
Heat Flux calculation inside domain	shikamaru	Fluent UDF and Scheme Programming	0	November 14, 2012 10:51
monitoring dynamic heat flux through a surface	abdnakhi	FLUENT	0	August 15, 2005 10:57

All times are GMT -4. The time now is 14:12.