Inteface in fluent

Suyash26 · March 23, 2013, 03:19

Hi, i am doing the heat transfer simulation between fluid and solid. So I have created two bodies in one part(one for fluid and one for solid) and I have generated the conformal mesh, created the name selcection. But when I go to fluent set up. It shows me error while initializing solution: Init_Flow: unassigned interface_zones.

vasava · March 25, 2013, 04:06

Are you sure you have proper interface at the common boundaries?

Suyash26 · March 25, 2013, 06:58

I was able to do the problem when I created two different parts. But when I created two bodies in one part only, I wasn't able to give mesh interface. I need to use non-conformal mesh in case of two different parts. Is it possible to assign mesh interface by using single part?

vasava · March 25, 2013, 07:20

No. However if you have a situation where a hot pipe is heating the fluid you could avoid simulating the wall. But with two domain you do need the interface.

March 23, 2013, 03:19	Inteface in fluent	#1
Suyash26 New Member Suyash Patkar Join Date: Nov 2012 Posts: 9 Rep Power: 14	Hi, i am doing the heat transfer simulation between fluid and solid. So I have created two bodies in one part(one for fluid and one for solid) and I have generated the conformal mesh, created the name selcection. But when I go to fluent set up. It shows me error while initializing solution: Init_Flow: unassigned interface_zones.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
A Problem of Fluent Interpreted UDF: parse error	knight	Fluent UDF and Scheme Programming	25	August 16, 2018 11:26
Two questions on Fluent UDF	Steven	Fluent UDF and Scheme Programming	7	March 23, 2018 04:22
heat transfer with RANS wall function, over a flat plate (validation with fluent)	bruce	OpenFOAM Running, Solving & CFD	6	January 20, 2017 07:22
Alias problem when starting FLUENT from command line	batch_error	FLUENT	0	May 24, 2012 09:20
Problems in lauching FLUENT	Lourival	FLUENT	3	January 16, 2008 17:48

March 25, 2013, 04:06		#2
vasava Senior Member Paritosh Vasava Join Date: Oct 2012 Location: Lappeenranta, Finland Posts: 732 Rep Power: 23	Are you sure you have proper interface at the common boundaries?

March 25, 2013, 06:58		#3
Suyash26 New Member Suyash Patkar Join Date: Nov 2012 Posts: 9 Rep Power: 14	I was able to do the problem when I created two different parts. But when I created two bodies in one part only, I wasn't able to give mesh interface. I need to use non-conformal mesh in case of two different parts. Is it possible to assign mesh interface by using single part?

March 25, 2013, 07:20		#4
vasava Senior Member Paritosh Vasava Join Date: Oct 2012 Location: Lappeenranta, Finland Posts: 732 Rep Power: 23	No. However if you have a situation where a hot pipe is heating the fluid you could avoid simulating the wall. But with two domain you do need the interface.