Reference zone in Fluent

akash · March 6, 2013, 06:18

Hello,

I have two zones in Fluent. Say zone 1 and zone 2. I want to monitor absolute velocity at a point in zone 1. I'm confused of which zone to select as the reference zone.

What if I don't select any zone under reference zone in reference values dialog box, and while initializing the solution, I select absolute reference frame. Will I get absolute velocity at that point?

Thank You.

mqasimali · March 13, 2013, 17:39

will you please elaborate the geometry??
how zone 1 is linked up with 2?
side by side or up and down?

March 6, 2013, 06:18	Reference zone in Fluent	#1
akash New Member Akash Join Date: Jan 2013 Location: India Posts: 20 Rep Power: 13	Hello, I have two zones in Fluent. Say zone 1 and zone 2. I want to monitor absolute velocity at a point in zone 1. I'm confused of which zone to select as the reference zone. What if I don't select any zone under reference zone in reference values dialog box, and while initializing the solution, I select absolute reference frame. Will I get absolute velocity at that point? Thank You.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Fluent3DMeshToFoam	simvun	OpenFOAM Meshing & Mesh Conversion	50	January 19, 2020 16:33
It would be wonderful if a tool for FoamToTecplot is available	luckyluke	OpenFOAM Post-Processing	165	November 27, 2012 07:54
OpenFOAM 1.6 ext - Compilation errors - Fedora 17(32bit)	toolpost	OpenFOAM Installation	15	September 21, 2012 10:38
[Commercial meshers] Conversion form .ccm to openFoam	ViktoriaE	OpenFOAM Meshing & Mesh Conversion	1	November 29, 2011 17:40
Fluent incident radiation problem	Michael Schwarz	Main CFD Forum	0	October 21, 1999 06:56

March 13, 2013, 17:39		#2
mqasimali New Member Qasim Ali Join Date: Mar 2013 Location: Islamabad, Pakistan Posts: 18 Rep Power: 13	will you please elaborate the geometry?? how zone 1 is linked up with 2? side by side or up and down?