 |
 |
 |
|
|
|
[Sponsors] | ||||
February 25, 2013, 08:42
|
Motored Simulation
|
#1 |
|
New Member
Cristiano
Join Date: Feb 2013
Posts: 11
Rep Power: 13  |
Hi!
I'm working on a 2 Stroke Diesel Engine. I tried with "Simulate Diesel Combustion Using Eddy-Dissipation Model" but I've some problem with pressure (too elevate). Now I would try to simulate the engie in motored configuration. Could you explain how can I do this? I tried to set 0 for the mass flow injection in Eddy model, but the pressure is too elevate however. If you know, please say me a possible tutorial to use for this case. Thank you! |
|
|
|
|
 |
| Tags |
| motored mobile mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Why my simulation not agree with the wind tunnel experiment | zhaowei | CFX | 4 | July 11, 2015 04:36 |
| Solar Radiation in OpenFOAM | plainstyle | OpenFOAM Running, Solving & CFD | 15 | July 8, 2014 05:43 |
| Simulation of a complex wing in solidworks flow simulation | niels1900 | FloEFD, FloWorks & FloTHERM | 6 | April 20, 2011 11:44 |
| Continuous vs interrupted simulation | sega | OpenFOAM Running, Solving & CFD | 4 | November 3, 2008 15:29 |
| strange simulation error | Ralf Schmidt | FLUENT | 2 | May 4, 2007 14:02 |
Linear Mode
