problem with bodies transferred from the mesher

yahya · February 21, 2013, 21:47

I built a huge model using designmodeler that consist of more than 300 bodies, and then I did my mesh using meshing application available in ANSYS 14, in addition, I have created a named selection for several faces and bodies.
However, when i transfer it to fluent all the bodies is transferred by itself, i.e. like if I have 250 bodies as interior each one is transferred by itself and i need to specify it as interior 250 time in the boundary conditions box in fluent, in addition, for the named selections if I selected 10 faces as walls, when I transfer it to fluent each one is transferred by itself as wall (not all as package).
So in summary, i need when I transfer the model to be transferred as one package for interior and one package for each named selection, because this problem take long time to upload the geometry.

best regards,
Yahya

chaosh · February 27, 2013, 14:35

Did you combine all these bodies into one 'part' in Design Modeler before meshing? If not, you should - unless you plan to have a sliding interface type situation.

February 21, 2013, 21:47	problem with bodies transferred from the mesher	#1
yahya Member yahya Join Date: Jul 2012 Posts: 43 Rep Power: 14	I built a huge model using designmodeler that consist of more than 300 bodies, and then I did my mesh using meshing application available in ANSYS 14, in addition, I have created a named selection for several faces and bodies. However, when i transfer it to fluent all the bodies is transferred by itself, i.e. like if I have 250 bodies as interior each one is transferred by itself and i need to specify it as interior 250 time in the boundary conditions box in fluent, in addition, for the named selections if I selected 10 faces as walls, when I transfer it to fluent each one is transferred by itself as wall (not all as package). So in summary, i need when I transfer the model to be transferred as one package for interior and one package for each named selection, because this problem take long time to upload the geometry. best regards, Yahya

February 27, 2013, 14:35	DM	#2
chaosh New Member sp Join Date: Jul 2011 Posts: 23 Rep Power: 15	Did you combine all these bodies into one 'part' in Design Modeler before meshing? If not, you should - unless you plan to have a sliding interface type situation.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
area does not match neighbour by ... % -- possible face ordering problem	St.Pacholak	OpenFOAM	11	September 4, 2024 05:28
conduction problem	venkataramana	OpenFOAM	3	December 1, 2013 08:30
UDF compiling problem	Wouter	Fluent UDF and Scheme Programming	6	June 6, 2012 05:43
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 07:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 20:13