|
[Sponsors] |
July 26, 2012, 21:52 |
Geometry Generation Fail
|
#1 |
New Member
|
Good Night everyone,
I'm trying to do a fluid simulation over an Eppler 423 airfoil. I'm following this tutorial https://confluence.cornell.edu/displ...oil+-+Geometry. I could generate the curve, the surface, the grid and the grid surface. But then I have to create two lines, one horizontal line dividing the grid in half and one vertical line dividing the grid in half. I can create the horizontal line but I cannot create the vertical line. When I try to generate the line by selecting the sketch and generating the curve I have the error: "Boolean operation failed". Does anybody know how can I fix it? Thank you |
|
July 27, 2012, 03:02 |
|
#2 |
Senior Member
Marion
Join Date: Jul 2012
Location: France
Posts: 122
Rep Power: 15 |
Hi,
Could you specify what software you are using? It looks like your problem is more geometry/meshing related, therefore maybe you should post in the appropriate section of the forum to get an answer? Marion. |
|
July 27, 2012, 08:45 |
Thanks
|
#3 |
New Member
|
Hello Marion,
Yes it is geometry related. I'm new on this forum so thanks, I'll post it in the apropriate forum. By the way I'm using Ansys Workbench - Fluent to do the simulation and I'm creating the geometry there. Thank you very much, Amanda |
|
Tags |
boolean, fluent 12.1, geometry simulation |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about Geometry vs. Meshes | EphemeralMemory | ANSYS Meshing & Geometry | 2 | December 8, 2016 14:02 |
Importing CAD geometry and Editing edges to match | Ahmed | CFX | 15 | March 21, 2016 13:39 |
Geometry and mesh generation in OpenFoam | pokeng | OpenFOAM Pre-Processing | 1 | October 28, 2011 22:40 |
3d geometry mesh generation | mach13 | ANSYS Meshing & Geometry | 10 | September 10, 2009 12:03 |
Simulation of Flow through Complex 3D Geometry | EmersonKB | CFX | 5 | July 2, 2009 09:17 |