Gambit mesh: tangent edges and high skewness

CaroVandame · May 3, 2012, 19:47

Hello everyone

I'm trying to mesh a bagless filter which looks like the one on the picture with hexahedral cells only.
At first my inlet was one volume and my "center piece" was another one. However, it creates a very small sliver at the connection, and meshing it leads to high skewness cells.

Here are my questions:
-is there an easy way to select a particular cell and refine it in one direction in Gambit?
-is this one case where using virtual geometries could help? I could create virtual faces that include both my sliver face and my central face, and mesh it easily, however, at the connections planes, how do I match the meshes?

Any idea/tip/... will be greatly appreciated, I'm quite new to Gambit!

Thanks
Caroline

LuckyTran · May 3, 2012, 22:51

Try posting in the meshing forum. This forum is for Fluent!

CaroVandame · May 3, 2012, 23:21

Sorry about that, just re-posted in the right forum, will delete this thread

May 3, 2012, 19:47	Gambit mesh: tangent edges and high skewness	#1
CaroVandame New Member Caroline Vandame Join Date: Aug 2010 Posts: 26 Rep Power: 16	Hello everyone I'm trying to mesh a bagless filter which looks like the one on the picture with hexahedral cells only. At first my inlet was one volume and my "center piece" was another one. However, it creates a very small sliver at the connection, and meshing it leads to high skewness cells. Here are my questions: -is there an easy way to select a particular cell and refine it in one direction in Gambit? -is this one case where using virtual geometries could help? I could create virtual faces that include both my sliver face and my central face, and mesh it easily, however, at the connections planes, how do I match the meshes? Any idea/tip/... will be greatly appreciated, I'm quite new to Gambit! Thanks Caroline

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 07:41
[ICEM] Negative volume error in hybrid mesh	siw	ANSYS Meshing & Geometry	4	September 3, 2014 06:25
[ICEM] Gambit to ICEM, any advices ?	Santos-Dumont	ANSYS Meshing & Geometry	15	February 28, 2012 20:07
Help needed with Cornell's Gambit airfoil tutorial	AW	FLUENT	6	February 26, 2010 23:42

May 3, 2012, 22:51		#2
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,761 Rep Power: 66	Try posting in the meshing forum. This forum is for Fluent!

May 3, 2012, 23:21		#3
CaroVandame New Member Caroline Vandame Join Date: Aug 2010 Posts: 26 Rep Power: 16	Sorry about that, just re-posted in the right forum, will delete this thread