dynamique mesh

cheredha · June 8, 2010, 19:21

I have a problem with the dynamic mesh in fluent displays an error message as I Click <build>

Here the main window

the messege is

'nmake' is not recognized as internal or external command, operable program or batch file.

help me s v p

cheredha · June 8, 2010, 19:47

Is anyone there

paka · June 10, 2010, 03:32

Not sure what might be the reason, but the way it look I would say your compiler is not hooked up to your Fluent distribution. Try to interpret your function instead of using precompiled one. At least in Ansys Fluent 12 interpret function works well, I used to have some trouble with Fluent 6.3.

Hope that helps.

cheredha · June 10, 2010, 06:00

thank you paka, this course has solved the problem, the program is not installed nmake, now I have another problem, when making the file source, put it with the file. cas, where I was a (where I instaled the fluent!).

June 8, 2010, 19:21	dynamique mesh	#1
cheredha Member alliche redha Join Date: Jun 2010 Posts: 53 Rep Power: 16	I have a problem with the dynamic mesh in fluent displays an error message as I Click <build> Here the main window the messege is 'nmake' is not recognized as internal or external command, operable program or batch file. help me s v p Last edited by cheredha; June 8, 2010 at 20:13.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dynamic Mesh Problem.	Tom Clark	FLUENT	10	June 21, 2021 05:27
Meshing aifoil in ICEM	student123a	ANSYS Meshing & Geometry	13	December 8, 2010 11:40
dynamique mesh	cheredha	FLUENT	0	June 8, 2010 13:35
2d irregular grid	Remy	Main CFD Forum	1	December 22, 2008 05:49
General questions on grid-based computing	Adrin Gharakhani	Main CFD Forum	21	June 5, 2000 14:47

June 8, 2010, 19:47		#2
cheredha Member alliche redha Join Date: Jun 2010 Posts: 53 Rep Power: 16	Is anyone there

June 10, 2010, 03:32		#3
paka Senior Member Join Date: Mar 2009 Posts: 225 Rep Power: 18	Not sure what might be the reason, but the way it look I would say your compiler is not hooked up to your Fluent distribution. Try to interpret your function instead of using precompiled one. At least in Ansys Fluent 12 interpret function works well, I used to have some trouble with Fluent 6.3. Hope that helps.

June 10, 2010, 06:00		#4
cheredha Member alliche redha Join Date: Jun 2010 Posts: 53 Rep Power: 16	thank you paka, this course has solved the problem, the program is not installed nmake, now I have another problem, when making the file source, put it with the file. cas, where I was a (where I instaled the fluent!).