 |
 |
 |
|
|
|
[Sponsors] | ||||
UDF for Heat transfer coefficient with multiphase |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 10, 2020, 09:53
|
UDF for Heat transfer coefficient with multiphase
|
#1 |
|
Member
ssa
Join Date: Sep 2018
Posts: 93
Rep Power: 8  |
Hi all,
I am doing Euler-Euler simulation with air and solid. I have expressions for heat transfer coefficient for air to wall (H_aw), solid to wall (H_sw) and air to solid(H_as). I programmed H_as with DEFINE_EXCHANGE_PROPERTY. Now my question is how to program H_aw and H_sw.? If I do with DEFINE_PROFILE, I can load only one UDF (H_aw or H_sw) in the boundary conditions. Looking forward to your suggestions. Thanks, Senthil. |
|
|
|
|
|
September 16, 2020, 10:06
|
|
#2 |
|
Senior Member
Alexander
Join Date: Apr 2013
Posts: 2,363
Rep Power: 34 |
never did it, but could you make 2 DEFINE_pROFILE functions in same UDF for H_aw and H_sw respectively?
__________________
best regards ****************************** press LIKE if this message was helpful |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Heat transfer coefficient - what is waht | Stan | FLUENT | 28 | December 29, 2021 17:29 |
| UDF for interfacial mass transfer in multiphase flow | snr1 | Fluent Multiphase | 0 | June 19, 2019 14:18 |
| Surface Heat Transfer Coefficient driven by a UDF, using coupled wall | ryanbezz11 | CFD Freelancers | 1 | March 16, 2018 04:01 |
| FLUENT UDF for heat transfer coefficient | EngZara | CFD Freelancers | 1 | July 9, 2017 15:30 |
| Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 18:30 |
Linear Mode
