 |
 |
 |
|
|
|
[Sponsors] | ||||
April 15, 2019, 20:10
|
Two-phase separator plane coordinate
|
#1 |
|
New Member
Ehsan
Join Date: Mar 2019
Posts: 1
Rep Power: 0  |
Hi
In a two-phase problem, I need an approximate coordinate (Normal vector, etc) of the separating plane of two phases per cell. To solve this problem, a multiphase VOF model has been used. Is there any macro in the UDF environment to get the coordinates of the plane, or should the coordinates of this plane be estimated using the VOF gradient? Thanks & Regards, Ehsan |
|
|
|
|
 |
| Tags |
| c_vof, c_vof_g, multiphase, vof |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| twoPhaseEulerFoam: dispersed phase not conservative? | RL-S | OpenFOAM Running, Solving & CFD | 6 | May 8, 2018 09:46 |
| Adding an energy source term to a phase with reactions | lxlxlxt | Fluent Multiphase | 0 | February 10, 2014 21:42 |
| multi phase flow with chemical reactions in one phase | Habibfateh | OpenFOAM Programming & Development | 0 | February 10, 2014 08:33 |
| Derive fixed number of phase from clone () in multiphaseEulerFoam Solver | Aj Nair | OpenFOAM Programming & Development | 0 | December 16, 2013 21:41 |
| Extract primary phase thread in VOF with 3 phases | Eric | FLUENT | 2 | July 7, 2011 03:22 |
Linear Mode
