 |
 |
 |
|
|
|
[Sponsors] | ||||
February 24, 2019, 01:56
|
Partition error
|
#1 |
|
New Member
dhdh89
Join Date: Oct 2018
Posts: 7
Rep Power: 8  |
I am developing a UDF that stores the UDM by calculating information from the membrane.
If I use serial mode, I can calculate it. However, if I use parallel (56 cores), the calculation value will be strange along the boundary of the partition as shown in the figure. Is there a way? Thank you in advance. |
|
|
|
|
|
February 24, 2019, 16:08
|
|
#2 |
|
Senior Member
Join Date: Nov 2013
Posts: 1,965
Rep Power: 27 |
It is very difficult to make a suggestion for how you can improve your code, if you don't show your code.
|
|
|
|
|
|
|
February 24, 2019, 22:50
|
|
#3 |
|
Senior Member
Alexander
Join Date: Apr 2013
Posts: 2,363
Rep Power: 34 |
switch off Node Values in contours options
if you are not sure about your code, put it here best regards |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 19:00 |
| OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 10:17 |
| Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 03:32 |
| Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 21:50 |
| DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 18:51 |
Linear Mode
