|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
MCKoz
Join Date: Apr 2018
Posts: 9
Rep Power: 8 ![]() |
Hi all,
I currently have a UDS set up with an inlet species mass fraction. So far, I have included a UDF that describes the decrease in this mass fraction in the volume over time (I am modeling a death rate). In addition to this setup of modeling a death rate, I want to include a correlation that describes the reaction of this species (those that have not died) into another type of species. I'm currently not sure how to go about doing this. Do I need to create another UDS that the remaining species can transform into and then apply the reaction correlation to the second UDS? Additionally, would this reaction term use a DEFINE_SOURCE macro, as I did for the death rate of the species? Any guidance would be greatly appreciated on this topic. |
|
![]() |
![]() |
![]() |
Tags |
user defined function |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
A general question on using UDF for defining reaction kinetics | Morijef | Fluent UDF and Scheme Programming | 0 | September 19, 2018 15:37 |
Is it possible to add volumetric udf that is dependent on already specified reaction? | sooraj546 | FLUENT | 0 | May 22, 2018 15:05 |
[help!] Empirical Reaction Rate UDF | cinwendy | Fluent UDF and Scheme Programming | 8 | June 14, 2017 07:16 |
surface reaction UDF | taekyu8 | Fluent UDF and Scheme Programming | 1 | June 16, 2013 03:23 |
UDF : Chemical Reaction in Catalytic Converter | adhimac | FLUENT | 1 | March 27, 2001 14:04 |