Home > Forums > Software User Forums > ANSYS > FLUENT > Fluent UDF and Scheme Programming

using a point as sensor for boundary condition

Updated Threads

Reply

Search this Thread

November 9, 2018, 04:51	using a point as sensor for boundary condition	#1
erman New Member erman Join Date: Nov 2013 Posts: 6 Rep Power: 13	Dear CFD Users, I have a temperature boundary condition which is dependent on a point's temperature (as a sensor). I am trying to prepare my UDF file but i don't have enough experience with it. I am kindly asking for help about it. I tried to use two different tutorials but it was not succesfull;cfd.jpg Last edited by erman; November 9, 2018 at 09:23.

Reply

Tags

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
createPatch cyclic boundary condition	KateEisenhower	OpenFOAM Pre-Processing	3	September 4, 2018 15:30
Constant mass flow rate boundary condition	sahm	OpenFOAM	0	June 20, 2018 23:45
updating boundary condition after one iteration and permanently	babakflame	OpenFOAM Programming & Development	2	June 22, 2017 23:15
Floating point error and divergence detected	aannjj	FLUENT	0	July 2, 2013 04:44
[Gmsh] Gmsh and samplesurface	touf	OpenFOAM Meshing & Mesh Conversion	2	December 10, 2007 03:27

All times are GMT -4. The time now is 02:59.