[husywfl]

Hi everyone,

I am doing a simulation about boundary growth in FLUENT. If a particle hits the wall, then the fluid cell near the wall will be converted into solid, similarly discribing the particle deposition on the wall. But I'm wondering how can I change a fluid cell to solid like paper "Development of a Predictive CFD Fouling Model for Diesel Engine Exhaust Gas Systems" says. I don't know which kind of function was used in their UDFs.

Figure below shows the fouling growth methodology they use (comes from paper: "Development of a Predictive CFD Fouling Model for Diesel Engine Exhaust Gas Systems" ).

Hope someone can give me some tips.

Thanks in advance.

Wang Fei-Long

[sudatang]

Hi Wang Fei-Long,
I am also doing a simulation about boundary growth in FLUENT, I have read you paper(real-time fouling characteristics of a typical heat exchanger ...). can give me some tips about the boundary growth .
Thanks in advance.
Tang Ming

[husywfl]

Qq191922934

[litzj]

i have same purpose for cfd deposition

is there any advance in this question?