run problem

sajjad taghavi · May 5, 2014, 05:44

Hi every body
I have the same problem in each udf that I write
I write my udf (e.g. for the inlet velocity profile), compile it successfully and hook it. but when i want to run fluent, it doesn't work (fluent doesn't apply the profile) and even it gives me no values for flow variables. i had this problem with a source term before and i couldn't find its solution.

what should i do?

bluenail · May 9, 2014, 12:22

Please upload your code.

I think this is initial value problem.

unless your code is wrong Even though you compile, hook successfully,

it's not work

sorry for poor english

May 5, 2014, 05:44	run problem	#1
sajjad taghavi New Member sajjad taghavi Join Date: Feb 2014 Posts: 6 Rep Power: 12	Hi every body I have the same problem in each udf that I write I write my udf (e.g. for the inlet velocity profile), compile it successfully and hook it. but when i want to run fluent, it doesn't work (fluent doesn't apply the profile) and even it gives me no values for flow variables. i had this problem with a source term before and i couldn't find its solution. what should i do?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem run simpleFoam	ynos	OpenFOAM Running, Solving & CFD	1	December 18, 2013 12:13
Problem with cyclic bc when run on parallel	Tek	OpenFOAM	2	January 20, 2011 15:40
Parallel Run problem	shhe	OpenFOAM Running, Solving & CFD	1	April 27, 2010 07:52
transient problem run in steady state	luigi	FLUENT	4	March 13, 2008 07:54
Problem on Parallel Run Setup	Hamidur Rahman	CFX	0	September 23, 2007 18:11

May 9, 2014, 12:22		#2
bluenail New Member hana Join Date: May 2014 Posts: 23 Rep Power: 12	Please upload your code. I think this is initial value problem. unless your code is wrong Even though you compile, hook successfully, it's not work sorry for poor english