How to add source for UDS on a virtual surface?

SimulatingFlow · May 16, 2013, 15:58

Hello, Please help me to add a source term for a UDS on a virtual surface in the domain.

I use a simple 2D axisymmetrical geometry for my simulation, which has a inlet and outlet. Then I use the command "/surface/line-surface" to add a virtual surface in the domain. I want to add a source term to the user-defined-scalar equation along this line. How to find the cells at which the line is located, so that the source can be added to these cells?

Please help. Thank you.

mvee · May 22, 2013, 09:11

Hi

Source term refers to the volume and applied on the cell centroid. Source can not be on line or surface. This could be flux only. Line can be traced by its ID and flux can be imposed through flux condition.

Best wishes
Mvee

May 16, 2013, 15:58	How to add source for UDS on a virtual surface?	#1
SimulatingFlow New Member Jaculus Join Date: May 2013 Posts: 1 Rep Power: 0	Hello, Please help me to add a source term for a UDS on a virtual surface in the domain. I use a simple 2D axisymmetrical geometry for my simulation, which has a inlet and outlet. Then I use the command "/surface/line-surface" to add a virtual surface in the domain. I want to add a source term to the user-defined-scalar equation along this line. How to find the cells at which the line is located, so that the source can be added to these cells? Please help. Thank you.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
wmake compiling new solver	mksca	OpenFOAM Programming & Development	14	June 22, 2018 07:29
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 12:05
Relationship of Surface Source and Radiation	JosephKim	FloEFD, FloWorks & FloTHERM	2	December 10, 2013 00:44
mixerVesselAMI2D's mass is not balancing	sharonyue	OpenFOAM Running, Solving & CFD	6	June 10, 2013 10:34
source term for energy source from a wall surface	rahulsharma	FLUENT	0	February 1, 2010 03:00

May 22, 2013, 09:11		#2
mvee Senior Member Vaze Join Date: Jun 2009 Posts: 172 Rep Power: 17	Hi Source term refers to the volume and applied on the cell centroid. Source can not be on line or surface. This could be flux only. Line can be traced by its ID and flux can be imposed through flux condition. Best wishes Mvee