Access Material library in UDF

icemesh · March 4, 2013, 06:03

Hi,
I am writing a UDF in order to implement a vaporization/flash-boiling law for DPM-Calculations.

Now I have the following problem:
I have a droplet surface at boiling Temperature T_b, and the gas phase is at temperature T_g. In the calculations for the evaporaton mass flow from droplet to gasflow I need specific heat, thermal conductivity and viscosity of the gasphase, but at reference temperature calculated as

T_ref=2/3*T_b+1/3*T_g.

In the UDF-manual it is described I can access the specific heat with C_CP(c,t) but this would give me the specific heat of the cell, meaning at T_g.

How can I access the material property library, depending on material and temperature, is this possible?

Thanks for your help!

vasava · March 13, 2013, 06:46

Please check if this helps

http://combust.hit.edu.cn:8080/fluen...df/node109.htm

I am not sure if it answers your question.

icemesh · April 18, 2013, 08:53

Thanks, I have now defined my properties as UDFs and therefore can access them inmy UDF of interest.

March 4, 2013, 06:03	Access Material library in UDF	#1
icemesh New Member Join Date: Oct 2012 Posts: 8 Rep Power: 14	Hi, I am writing a UDF in order to implement a vaporization/flash-boiling law for DPM-Calculations. Now I have the following problem: I have a droplet surface at boiling Temperature T_b, and the gas phase is at temperature T_g. In the calculations for the evaporaton mass flow from droplet to gasflow I need specific heat, thermal conductivity and viscosity of the gasphase, but at reference temperature calculated as T_ref=2/3T_b+1/3T_g. In the UDF-manual it is described I can access the specific heat with C_CP(c,t) but this would give me the specific heat of the cell, meaning at T_g. How can I access the material property library, depending on material and temperature, is this possible? Thanks for your help!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
cannot load UDF library	jayilosa	Fluent UDF and Scheme Programming	3	November 16, 2011 13:44
UDF Data access problems	Mosheraa	FLUENT	4	June 17, 2011 14:16
UDF Access violation	therandomestname	FLUENT	0	April 15, 2011 18:31
Constant velocity of the material	Sas	CFX	15	July 13, 2010 09:56
Error in opening the UDF library	Sri	FLUENT	3	December 11, 2006 17:19

March 13, 2013, 06:46		#2
vasava Senior Member Paritosh Vasava Join Date: Oct 2012 Location: Lappeenranta, Finland Posts: 732 Rep Power: 23	Please check if this helps http://combust.hit.edu.cn:8080/fluen...df/node109.htm I am not sure if it answers your question.

April 18, 2013, 08:53		#3
icemesh New Member Join Date: Oct 2012 Posts: 8 Rep Power: 14	Thanks, I have now defined my properties as UDFs and therefore can access them inmy UDF of interest.