Appending field values to a file

teopetre · April 20, 2012, 06:03

Hi to all,

I want to export a lot of pressure values, for just one cell, each value per one time step. As I sought through Internet, I would have only the option to save these values in different files, resulting very much many of them. Does somebody know a command for appending the values in the same file, without deleting the previous ones. To mention that, I'm using a journal for exporting procedure, executed at each time step.

Thanks in advance!

Amir · April 20, 2012, 17:08

Hi,

Why didn't you use "solve->monitor ...." if you want to store values just for one cell?!

Bests,

teopetre · April 21, 2012, 10:13

Yeah right, I was stumbling upon that Execute Commands facility, so didn't realize this procedure. Thanks for the advice!

April 20, 2012, 06:03	Appending field values to a file	#1
teopetre New Member Petrut Teodor Join Date: Feb 2010 Location: Romania Posts: 12 Rep Power: 16	Hi to all, I want to export a lot of pressure values, for just one cell, each value per one time step. As I sought through Internet, I would have only the option to save these values in different files, resulting very much many of them. Does somebody know a command for appending the values in the same file, without deleting the previous ones. To mention that, I'm using a journal for exporting procedure, executed at each time step. Thanks in advance!

April 20, 2012, 17:08		#2
Amir Senior Member Amir Join Date: May 2009 Location: Montreal, QC Posts: 735 Blog Entries: 1 Rep Power: 23	Hi, Why didn't you use "solve->monitor ...." if you want to store values just for one cell?! Bests, __________________ Amir

April 21, 2012, 10:13	Good point!	#3
teopetre New Member Petrut Teodor Join Date: Feb 2010 Location: Romania Posts: 12 Rep Power: 16	Yeah right, I was stumbling upon that Execute Commands facility, so didn't realize this procedure. Thanks for the advice!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2.0.x on Mac OSX	niklas	OpenFOAM Installation	74	March 28, 2012 17:46
[OpenFOAM] Paraview command not found	hardy	ParaView	7	September 18, 2008 05:59
Problem with rhoSimpleFoam	matteo_gautero	OpenFOAM Running, Solving & CFD	0	February 28, 2008 07:51
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 15:00
error while compiling the USER Sub routine	CFD user	CFX	3	November 25, 2002 16:16