[inouzil]

Hi,

I get the following message when I do a DPM spray simulation. "The wall temperature is above the Leidenfrost temperature for 100.0% of the film area. This corresponds to 100.0% of the film mass, which is 3.34e-09 kg"

How do I change the leidenfrost temperature value? I understand that it must be above the boiling temperature of the fluid (around 300C in my case) and I want to set it as a high value. Not sure how to do that. Currently, the wall temperature is only about 38C maximum and I still get this message. Cant seem to find any help in the ansys manual.

Kindly assist.

Nouzil