|
[Sponsors] |
6DOF Dynamic mesh for a floating rigid body in fluent v20 |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 22, 2021, 06:02 |
6DOF Dynamic mesh for a floating rigid body in fluent v20
|
#1 |
New Member
Tushar Patel
Join Date: Sep 2021
Location: Germany
Posts: 3
Rep Power: 4 |
Hi everyone,
This is being my first post on this amazing platform. Actually, for my project work, I am trying to simulate a rectangular plate of dimensions (7.5*7.5) with 0.1m thickness over a wavy surface of ocean water. The condition was that the plate should be considered as a rigid plate that can easily float on the water surface and also can move with waves. I have tried different ways to analyze it with some normal kind of mesh and boundaries if I get some movements of the rigid plate then I will apply a very fine mesh for that with smaller timestep and more iterations. I am suffering from the 6DOF dynamic mesh problem, while I don't have much knowledge of that but I knew that fluent v20, v21 can run dynamic mesh without UDF. I have tried with mass and inertia tensor values but couldn't find the impact of waves on a plate. The geometry is quite simple, I have used a fluent multiphase VOF model with both open channel flow and open channel wave BC and gravity in the -Y direction. The system was ideally considered as ideal wave (Sinusoidal wave) and ocean current is not included yet(initial avg flow velocity is Zero). If there are any suggestions regarding this, please let me know. or any kind of help would be appreciable. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ship resistance shows wiggles when using Overset mesh and dynamic mesh in Fluent | Qingsong | FLUENT | 2 | March 21, 2022 15:08 |
Trouble modelling a 2D gear pump simulation using dynamic mesh in Ansys Fluent 19 | vivjk94 | Main CFD Forum | 0 | September 20, 2021 00:25 |
6dof model - floating body | flinde | FLUENT | 13 | March 6, 2021 14:32 |
[ANSYS Meshing] Fluent crashing with dynamic mesh | gdbb89 | ANSYS Meshing & Geometry | 2 | December 30, 2020 21:32 |
The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |