 |
 |
 |
|
|
|
[Sponsors] | ||||
how to set the deposition rate in fluent ddpm model? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 3, 2021, 07:32
|
how to set the deposition rate in fluent ddpm model?
|
#1 |
|
New Member
Han ZHOU
Join Date: May 2021
Posts: 1
Rep Power: 0  |
Hi everyone,
I'm a student of CFD and my internship project is a study of aerosol diffusion chambre, I'm using the DDPM model to simulate the case, and I need to set up a desposition rate k of the aerosol phase. I don't Know where it is and how to do because I only found the settings of wall boundray conditions of DPM ( trap ), but there's nowhere to set the deposation rate. Please help me if you know, thanks. |
|
|
|
|
|
| Tags |
| #deposation rate #ddpm |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Evaporation model in ansys Fluent 12.1 | oldisbest | Fluent UDF and Scheme Programming | 12 | March 26, 2020 10:11 |
| set up DPM model in fluent | ebtedaei | FLUENT | 0 | February 20, 2018 11:39 |
| Which Multiphase Model Should be selected in Fluent for my below described simulation | oberstar | Fluent Multiphase | 0 | September 28, 2017 13:05 |
| Is it possible to model natural convection in a 2D horizontal model in fluent | caitoc | FLUENT | 1 | May 5, 2014 14:32 |
| surface deposition rate via udf - fluent 6 | Greg Perkins | FLUENT | 1 | March 3, 2003 04:01 |
Linear Mode
