Home > Forums > Software User Forums > ANSYS > FLUENT > Fluent Multiphase

Simulation of a 3D microfluidic flow focusing device

Updated Threads

Reply

Search this Thread

July 31, 2020, 07:24	Simulation of a 3D microfluidic flow focusing device	#1
adib_mohammad New Member Join Date: Jan 2015 Posts: 22 Rep Power: 11	I have created a 3d model based on flow focusing device (in micro scale), which consists of 3 inlets (one middle inlet = dispersed phase & two lateral inlets - continuous phase ). I am using laminar VOF model, and inlets with uniform velocity profiles. The simulation is supposed to generate droplets of dispersed phase carried by continuous phase to the outlet. HOWEVER, the dispersed phase sticks to the wall and crawls toward the outlet. THESE two images shows the geometry and volume fraction of the dispersed phase. https://ibb.co/s1Q78dL https://ibb.co/kc0xxJJ

Reply

Tags

fluent, microfluidics, vof model

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
About Some Concepts:Laminar flow, turbulent flow, steady flow and time-dependent flow	Jing	Main CFD Forum	8	October 5, 2018 18:02
Some questions about flow boiling simulation in Fluent	beastieboys6	FLUENT	8	November 21, 2017 00:47
Flow rate restriction simulation set-up	siw	CFX	4	February 16, 2016 13:15
Preparing Simulation of a Sphere in a Flow	PonchO	OpenFOAM Pre-Processing	1	November 11, 2015 16:40
Expert parameter to stop the fluid flow simulation	KK	CFX	1	February 25, 2008 17:29

All times are GMT -4. The time now is 12:44.