|
[Sponsors] |
How to resolve Negative cell volume issue in fluent? |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Join Date: May 2020
Posts: 10
Rep Power: 6 ![]() |
I am trying to simulate the dynamic lift of Semi-planing hull during high speeds. For this I have prepared setting in fluent for dynamic mesh. But I am facing negative cell volume error. After reading discussions and having some suggestions. I have tried with making a large domain, turning off the inflation layer and changing values in remeshing. Nothing worked for me. Please help. Suggestions are needed. And If you are open to have a look on my simulation file. Pls drop your email. Thanks
|
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
[blockMesh] blockMesh error - Negative Volume Block | adoledin | OpenFOAM Meshing & Mesh Conversion | 2 | June 22, 2016 10:44 |
Error:Negative cell volume! - Setup Fluent for FSI Benchmark TUREK/HRON | nova.08 | FLUENT | 0 | August 5, 2015 06:50 |
Negative Volume during Mesh Motion Analysis | giov_ingr | FLUENT | 2 | December 13, 2013 06:09 |
FLUENT negative volume | eishinsnsayshin | FLUENT | 1 | March 27, 2012 04:03 |