[uthakur]

Hi Everyone,
I am simulating a conical spouted bed reactor. It is conical section with cylindrical section on the top. In the conical portion, bed material is kept. The aim is to provide air from the bottom inlet to produce a stable spout (jet type). However, I have tried all the models and methods used in literature but unable to get results. I dont know where am I doing mistake in the simulation. The particles inside doesnt show the behavior as it suppose to show. I have tried the literature models too but could successfully solve it. If anyone has any experience simulating a spouted bed reactor please give me some guidance.
Thank you and I would look forward to any response.


Kind Regards
Ujjwal Thakur