 |
 |
 |
|
|
|
[Sponsors] | ||||
September 19, 2019, 15:47
|
Slug flow set up in fluent
|
#1 |
|
New Member
AISHWARY PRATAP
Join Date: Sep 2019
Posts: 1
Rep Power: 0  |
Actually I want to know how we set up the problem of slug flow in a rectangular duct in 2 dimensional analysis. In my problem a rectangular duct is of 4 m length and 10 cm width dimension in which a separator plate is fixed at 5 cm from bottom of 50 cm length. So from upper half air flows with 9 m/s and in lower half water is flows with 1.5 m/s. Problem is to identify kinetic energy of slug. In this problem I actually stuck at a point from where adapt and region is selected for patch and so on further processes. So please any one help me for this problem.
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ansys Licence Serve on Ubuntu 16.04 LTS | david.pasquale | ANSYS | 2 | January 20, 2017 12:52 |
| The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 23:56 |
| [snappyHexMesh] determining displacement for added points | CFDnewbie147 | OpenFOAM Meshing & Mesh Conversion | 1 | October 22, 2013 10:53 |
| Different flow patterns in CFX and Fluent | avi@lpsc | FLUENT | 4 | April 8, 2012 07:12 |
| Modeling Slug flow | Demetrios | FLUENT | 0 | November 23, 2006 17:49 |
Linear Mode
