|
[Sponsors] |
May 12, 2017, 04:39 |
Heat transfer in a thermosiphon
|
#1 |
New Member
Hardik
Join Date: Mar 2017
Posts: 4
Rep Power: 9 |
Modelling phase change and basic heat transfer in a vertical thermosiphon. Have divided the the geometry walls into evaporator section condenser section and adiabatic section. Set the case up using VOF model, ev-condensation model and used a UDF, but didnt get bubble formation or condensation on the walls.
Need help trying to figure out the mistake in the simulation setup. Any help would be appreciated. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heat transfer using all modes | bhups45 | FLUENT | 0 | June 19, 2016 08:02 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 08:00 |
Question about heat transfer simulation | Anna Tian | Main CFD Forum | 0 | January 25, 2013 19:53 |
Heat Transfer in Porous Medium | eryan | STAR-CD | 0 | September 28, 2010 14:14 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |