 |
 |
 |
|
|
|
[Sponsors] | ||||
March 8, 2017, 06:51
|
evaporation of water in to air flow
|
#1 |
|
New Member
mohammad alavi
Join Date: Dec 2016
Posts: 2
Rep Power: 0  |
i want to simulate evaporation of water in to air flow.I want to see decrease of temperature.I use DPM in fluent. I simulate water by injection droplet. after solution, when i draw contour of density, density was about 1 kg/m^3. I want droplet to combine and produce water by 1000 kg/m^3 density. how can i do that? thanks every one.
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Issues on the simulation of high-speed compressible flow within turbomachinery | dowlee | OpenFOAM Running, Solving & CFD | 11 | August 6, 2021 07:40 |
| problem with two phase flow (air injected in water) | miles_davis | OpenFOAM | 15 | March 31, 2021 10:36 |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
| governing equations in air water flow | ghazali | Main CFD Forum | 1 | March 8, 2015 23:47 |
| CFX CHT increased mass flow rate for water matters little for outlet air temperature | dingsheng1206 | CFX | 7 | December 4, 2013 21:04 |
Linear Mode
