Vof -- CFD Online Discussion Forums

October 7, 2016, 07:18

Vof

attaullah

New Member

Attaullah

Join Date: Aug 2016

Posts: 23

Rep Power: 10

Hi all,

I am simulating a venturi scrubber which has two inlets. One is for air and one is for water. Model = VOF. When i want to specify the boundary condition for inlet whose zone is velocity inlet . It did not show the momentum tab for specification of velocity.

Secondly in multi phase tab , it did not show the volume fraction for gas, only for liquid it shows the volume fraction.

Can somebody please help me with his knowledge.

regards;

Attaullah

Attached Images

	venturi 1.PNG (59.0 KB, 8 views)
	venturi.PNG (77.1 KB, 5 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
problem about VOF and species couple	Cloud	FLUENT	0	June 15, 2012 02:23
question about Heat transfer between two phases with VOF model	sooroo3	FLUENT	0	February 15, 2011 04:24
ATTENTION!! Validty of Fluent's VOF??	ozgur	Main CFD Forum	3	February 18, 2004 19:19
ATTENTION!! Validty of Fluent's VOF??	ozgur	FLUENT	1	February 18, 2004 12:59
Difficult BCs about Freesurface Simulation by VOF	Yongguang Cheng	FLUENT	0	September 19, 2003 08:39

All times are GMT -4. The time now is 15:04.