|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Join Date: Jul 2016
Posts: 1
Rep Power: 0 ![]() |
Dear all,
I am using a super computer to run my fluent simulation. In order to do that I need to write a job script. But I met some problems when initialization. I use the multiphase flow and open channel wave bc, to let the super computer run this case, I wrote the following code to initialize: /solve/initialize/compute defaults /solve/initialize/open-channel-auto-init /solve/initialize/initialize However, the error shows as: Error:Invalid specification of free surface and bottom level for numerical wave tank After that, some error code repeated like Fluent 14.5 Is that anything wrong with my initialization code or I should choose the new edition (I am using fluent 17.1)when writing the running code? Any answer will be really helpful. Many thanks! |
|
![]() |
![]() |
![]() |
Tags |
ansys 17.0, fluent 17.0, initialization, open channel flow, open channel wave bc |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFD in Naval Hydrodynamics, Off-Shore and Wave Modelling with OpenFOAM | hjasak | OpenFOAM Announcements from Other Sources | 2 | February 13, 2017 04:59 |
free surface level set in in Open Channel Wave BC | hamidcfd | Fluent Multiphase | 2 | December 12, 2016 12:08 |
Channel flow matlab code | infikamal5 | Main CFD Forum | 1 | October 5, 2015 16:45 |
LISA Code finding wave number. | vishal_s | OpenFOAM Programming & Development | 0 | September 16, 2014 15:20 |
UDF to apply a Spanwise velocity wave on a whole 3D rectangular channel domain | QBeast | Fluent UDF and Scheme Programming | 8 | October 15, 2013 05:10 |