|
[Sponsors] |
Evaporation heat loss modelling (water temperature below saturation)? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 17, 2015, 19:40 |
Evaporation heat loss modelling (water temperature below saturation)?
|
#1 |
New Member
Ahmed
Join Date: Apr 2015
Posts: 2
Rep Power: 0 |
Hello,
I’m looking for evaporation heat loss correlation from water surface to almost stagnant air. The water temperature is less than saturation temperature ranging between 15 to 80 degree C. Most of the correlations I found are for quite high air velocities. This appropriate correlation will be implemented in a UDF to simulate the heat loss from water surface. Hope somebody can give suggestion ** |
|
June 19, 2015, 07:35 |
|
#2 |
Senior Member
Khalid Baker
Join Date: Mar 2009
Location: IRAQ
Posts: 168
Rep Power: 17 |
Your description for the problem is too brief its better if you post a photo? As i understood you want to study two phase evaporation problem?
kbaker |
|
Tags |
evaporation model |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[openSmoke] libOpenSMOKE | Tobi | OpenFOAM Community Contributions | 562 | January 25, 2023 10:21 |
No liquid water exist in my Fuel Cell simulation | fatchang | FLUENT | 19 | October 15, 2018 15:27 |
Below Saturation Temperature Evaporation | amit.garg | FLUENT | 0 | May 11, 2015 04:59 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 18:11 |
heat and mass transfer durin water evaporation from wet surface | yigitktu | FLUENT | 0 | September 22, 2010 09:04 |