interface between molten metal and air

hb12 · April 26, 2015, 16:18

Hi everyone,

I try to model movement of molten steel free surface. When I use surface tension value greater than ~0.04 N/m, velocity increases to very high and non-physical values and also velocity magnitude in the bulk decreases too much.

it should be mentioned that when water surface tension is used, results are reasonable.

do you have any advice for this case?

vasava · April 29, 2015, 07:17

You may want want to check the location of the reference pressure. Chose the point which is all the time occupied by the lighter phase.

April 26, 2015, 16:18	interface between molten metal and air	#1
hb12 New Member HBarati Join Date: Nov 2014 Posts: 3 Rep Power: 12	Hi everyone, I try to model movement of molten steel free surface. When I use surface tension value greater than ~0.04 N/m, velocity increases to very high and non-physical values and also velocity magnitude in the bulk decreases too much. it should be mentioned that when water surface tension is used, results are reasonable. do you have any advice for this case?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
VOF simulate interface motion during evaporation	ellen peng	FLUENT	1	February 11, 2021 07:58
Heat transfer problem at fluid-solid interface	kiwikiwi	FLUENT	4	January 14, 2013 19:47
radiation of molton liquid metal in enclosure	richard	CFX	0	April 8, 2008 16:43
Model flow over / through expanded metal walkways.	andy2o	CFX	5	January 11, 2008 05:13
Metal queching with air + water mist	LW	FLUENT	0	January 12, 2000 14:08

April 29, 2015, 07:17		#2
vasava Senior Member Paritosh Vasava Join Date: Oct 2012 Location: Lappeenranta, Finland Posts: 732 Rep Power: 23	You may want want to check the location of the reference pressure. Chose the point which is all the time occupied by the lighter phase.