 |
 |
 |
|
|
|
[Sponsors] | ||||
January 14, 2015, 22:12
|
Water surface profile near outlet doesn
|
#1 |
|
Senior Member
Tanjina Afrin
Join Date: May 2013
Location: South Carolina
Posts: 169
Rep Power: 13  |
Hello all,
I am modeling water flowing from pipe to a reservoir with VOF. Turbulence model is K-e . As a BC, I am using mass flow inlet in Inlet, pressure outlet at reservoir outer wall, symmetry and pipe wall in outer surface of pipe. I am mainly concerned about flow in the pipe. The problem I am facing, water surface near outlet doesn't seem real to me. I am attaching a contour plot along symmetry plane. Regards, Tanjina |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mass imbalance problem in multiphase water and steam CFX case | Antech | CFX | 1 | October 26, 2020 05:03 |
| CFD of water waves phenomena-sawteeth at the free surface + slow execution time | nore5 | Main CFD Forum | 0 | May 10, 2013 13:45 |
| SSIIM 2, vertical elevation of the water surface, transient water flow parameters | Mummputz | Main CFD Forum | 6 | November 18, 2012 14:39 |
| VOF Outlet boundary condition in cfd - ace | JM | Main CFD Forum | 0 | December 15, 2006 09:07 |
| Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 10:11 |
Linear Mode
