air problem

fba · February 26, 2010, 10:17

Hello users,
I use these physics (air entraiment, bubble and phase change, density evaluation, drift flux) in flow3d to simulate the air effects within sea wave. The simulation crash with this error "dbug print from mrtcal - negative tn, rho, or rhoe"
Can you help me, please?
Thank you

MuxaB · February 26, 2010, 10:31

Quote:

Originally Posted by fba

Hello users,
I use these physics (air entraiment, bubble and phase change, density evaluation, drift flux) in flow3d to simulate the air effects within sea wave. The simulation crash with this error "dbug print from mrtcal - negative tn, rho, or rhoe"
Can you help me, please?
Thank you

you probably do not need bubble and phase change model. there are no large bubbles (larger than cell size) in the wave and certainly no phase change. For the drift-flux mode, what bubble (particle) size do you define?

fba · February 26, 2010, 10:40

It was 0.0 (default value), but now I run a new simulation with 0.01

mf_emp · October 2, 2012, 05:39

fabio did you find what was the problem?
because its my problem too!!

sirpinkyo · April 15, 2015, 02:06

Help me please what's the problem?

February 26, 2010, 10:17	air problem	#1
fba New Member fabio Join Date: Feb 2010 Posts: 3 Rep Power: 16	Hello users, I use these physics (air entraiment, bubble and phase change, density evaluation, drift flux) in flow3d to simulate the air effects within sea wave. The simulation crash with this error "dbug print from mrtcal - negative tn, rho, or rhoe" Can you help me, please? Thank you

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
tank filling problem with compressible air	Cle	FLUENT	1	March 9, 2012 00:02
air bubble is disappear increasing time using vof	xujjun	CFX	9	June 9, 2009 08:59
Problem of air bubbles in water. Please help !!!	xc	FLUENT	4	February 6, 2008 06:05
Help - Two Phase Flow - Convergence Problem	R.Sureshkumar	Main CFD Forum	1	February 22, 2000 04:24
extremely simple problem... can you solve it properly?	Mikhail	Main CFD Forum	40	September 9, 1999 10:11

February 26, 2010, 10:40		#3
fba New Member fabio Join Date: Feb 2010 Posts: 3 Rep Power: 16	It was 0.0 (default value), but now I run a new simulation with 0.01

October 2, 2012, 05:39		#4
mf_emp New Member Mahdiar Farhoudi Join Date: Feb 2012 Location: Tehran, Iran Posts: 17 Rep Power: 14	fabio did you find what was the problem? because its my problem too!!

April 15, 2015, 02:06		#5
sirpinkyo New Member Join Date: Dec 2012 Posts: 5 Rep Power: 14	Help me please what's the problem?