BC for two mesh blocks

Birkov · October 15, 2009, 10:29

Hi to all,

I have problem with BC for two mesh blocks. I read this forum and I found that the Flow is capable to solve it(I don't understand the answer) but I can't find how. I tried all BC (I know it's crazy) but I have results only for one mesh block.
Can you give me any suggestion?
Thanks for you time.

L.

Updated: I loaded data to Tecplot and I can see all results (BC - symmetry). But if anyone know how to show all in Flow it will be great. Thank you.

stefmascio · October 15, 2009, 11:35

hello Birkov,
do you mean that you have done a simulation with 2 mesh blocks and you don't see them in the results? (but with Tecplot yes)
It if it so, then probably you have to select the 2 mesh blocks by pushing the button "Mesh blocks" in the Analyze tab, near the bottom right of the window. By default you display only mesh block 1.

Birkov · October 16, 2009, 03:36

It was exactly my problem. Thank you very much. I have never seen this miracle button before

.
Thanks a lot.

October 15, 2009, 10:29	BC for two mesh blocks	#1
Birkov New Member Join Date: Jul 2009 Location: Prague Posts: 28 Rep Power: 0	Hi to all, I have problem with BC for two mesh blocks. I read this forum and I found that the Flow is capable to solve it(I don't understand the answer) but I can't find how. I tried all BC (I know it's crazy) but I have results only for one mesh block. Can you give me any suggestion? Thanks for you time. L. Updated: I loaded data to Tecplot and I can see all results (BC - symmetry). But if anyone know how to show all in Flow it will be great. Thank you. Last edited by Birkov; October 15, 2009 at 11:09.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to extend FSI 2D codes to 3D, need advises	abouziar	Main CFD Forum	1	May 30, 2008 05:08
ICEM clustering of mesh points and multiple edges	webhaw	CFX	4	July 25, 2007 17:29
basic of mesh refinement	arya	CFX	4	June 19, 2007 13:21
ICEM 10 mesh question	DAK565656	CFX	6	May 8, 2007 13:16
General questions on grid-based computing	Adrin Gharakhani	Main CFD Forum	21	June 5, 2000 14:47

October 15, 2009, 11:35		#2
stefmascio Member Stefano Join Date: Mar 2009 Posts: 59 Rep Power: 17	hello Birkov, do you mean that you have done a simulation with 2 mesh blocks and you don't see them in the results? (but with Tecplot yes) It if it so, then probably you have to select the 2 mesh blocks by pushing the button "Mesh blocks" in the Analyze tab, near the bottom right of the window. By default you display only mesh block 1.

October 16, 2009, 03:36		#3
Birkov New Member Join Date: Jul 2009 Location: Prague Posts: 28 Rep Power: 0	It was exactly my problem. Thank you very much. I have never seen this miracle button before . Thanks a lot.