 |
 |
 |
|
|
|
[Sponsors] | ||||
Q: how to do a good meshing in turbine usin gambit |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 15, 2009, 00:14
|
Q: how to do a good meshing in turbine usin gambit
|
#1 |
|
Guest
Posts: n/a
|
the photo that i had uploaded in my profile was part of my project..Currently Im facing a problem about how to do meshing for this turbine.. the brick channel is assume as sea. and the turbine is placing somewhere inside sea.. so the purpose of this project is nothing study the flow around the blade of turbine and study the effect in the wake or marine current turbine.. May i know how to do a good meshing in Gambit...thanks..
|
|
|
||
|
March 15, 2009, 00:15
|
Re: Q: how to do a good meshing in turbine usin ga *NM*
|
#2 |
|
Guest
Posts: n/a
|
|
|
|
|
||
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Error meshing a helicopter rotor with Gambit | Stefano | FLUENT | 3 | June 9, 2010 09:31 |
| [GAMBIT] Surface Meshing Issues in Gambit | Forrest | ANSYS Meshing & Geometry | 4 | March 27, 2009 15:22 |
| turbo turbine meshing with gambit | Mak | FLUENT | 3 | October 2, 2008 07:31 |
| 3d Gambit meshing shows out of memory | tamjid | FLUENT | 3 | September 27, 2008 02:01 |
| Meshing Aircraft with Gambit | Ed | FLUENT | 5 | November 9, 2004 06:04 |
Linear Mode
