 |
 |
 |
|
|
|
[Sponsors] | ||||
January 29, 2009, 05:00
|
how to view the complete results
|
#1 |
|
Guest
Posts: n/a
|
hi all When i simulate the program to get a a result each 10 seconds the results apear up to some time then no results apear after that while the simulation complete to the end so if I run to 120 sec the results apear at 10,20,30,....tofor example 70 and then no results apear while the simulation run to the end can any body help me
|
|
|
||
|
January 29, 2009, 13:50
|
Re: how to view the complete results
|
#2 |
|
Guest
Posts: n/a
|
Is the disk full? or could you post the xput namelist?
|
|
|
|
||
|
January 29, 2009, 14:11
|
Re: how to view the complete results
|
#3 |
|
Guest
Posts: n/a
|
thanks for your reply the capacity of the hard is ok but the problem is solved after deleting all the files in the folder except prepin.inp and flsgrf.dat and i don't know why
|
|
|
|
||
|
February 3, 2009, 13:25
|
Re: how to view the complete results
|
#4 |
|
Guest
Posts: n/a
|
What version of flow3d are you running?
|
|
|
|
||
|
February 3, 2009, 14:47
|
Re: how to view the complete results
|
#5 |
|
Guest
Posts: n/a
|
v 9.2
|
|
|
|
||
|
February 3, 2009, 14:56
|
Re: how to view the complete results
|
#6 |
|
Guest
Posts: n/a
|
This does not seem to happen with V9.3, can you upgrade?
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Generate a CFD domain from FEA results | Dave442 | Main CFD Forum | 0 | August 3, 2011 13:42 |
| [snappyHexMesh] How do I view results? | RygeltheXVI | OpenFOAM Meshing & Mesh Conversion | 1 | June 27, 2011 01:45 |
| Problems with repeating results | Lee | Siemens | 4 | May 26, 2006 04:39 |
| view the results from parallel v3.2 | matej | Siemens | 3 | July 30, 2004 03:13 |
| benchmark results | stefan | Siemens | 3 | September 10, 2001 10:48 |
Linear Mode
