Warning: Xmax mesh boundary for block 2 reset to type 9(inter-block boundary)

GaoLiyao-Sediment Scour · February 21, 2024, 11:51

Hello, everyone, it's my first post.
I'm doing a simulation of a spillway that have curve section. As you can see the computational domain is too big result in huge number of grids.
So I have an idea about using the "Grid Overlay" boundary in Xmax mesh for block 2 and Xmin mesh for block 3.
But when I setup complete, the preprocessing told me reset the "GO boundary" to "inter-block boundary", I can't understand why.
If anyone konw about it ,thank you a lot for replying.

GaoLiyao-Sediment Scour · February 21, 2024, 11:59

Why I click the "insert image" it doesn't work? Oh...

February 21, 2024, 11:51	Warning: Xmax mesh boundary for block 2 reset to type 9(inter-block boundary)	#1
GaoLiyao-Sediment Scour New Member Gao Liyao Join Date: Feb 2023 Posts: 4 Rep Power: 3	Hello, everyone, it's my first post. I'm doing a simulation of a spillway that have curve section. As you can see the computational domain is too big result in huge number of grids. So I have an idea about using the "Grid Overlay" boundary in Xmax mesh for block 2 and Xmin mesh for block 3. But when I setup complete, the preprocessing told me reset the "GO boundary" to "inter-block boundary", I can't understand why. If anyone konw about it ,thank you a lot for replying.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Openfoam Turbulent Car Simulation	meganrw	OpenFOAM Running, Solving & CFD	0	July 5, 2021 16:50
rSF: p divergence in combustor (wt negative value)	zonda	OpenFOAM Pre-Processing	4	April 10, 2018 07:59
multiphaseEulerFoam/tank discharge	ves	OpenFOAM Running, Solving & CFD	8	December 31, 2017 15:59
Question about adaptive timestepping	Guille1811	CFX	25	November 12, 2017 18:38
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 05:05

February 21, 2024, 11:59		#2
GaoLiyao-Sediment Scour New Member Gao Liyao Join Date: Feb 2023 Posts: 4 Rep Power: 3	Why I click the "insert image" it doesn't work? Oh...