 |
 |
 |
|
|
|
[Sponsors] | ||||
March 22, 2023, 15:31
|
baffles in flow3d
|
#1 |
|
New Member
Eli
Join Date: Jul 2022
Location: Canada
Posts: 13
Rep Power: 4  |
Hi everyone
I hope you are doing great I am modeling an open channel spillway and I want to monitor the flow rate in the entrance of my channel. I have put baffles right in the entrance of my channel using flux surface tab but I don't know where should I find the results of my baffles. is it in the flow3d post? I really appreciate your help. |
|
|
|
|
|
March 23, 2023, 23:11
|
|
#2 |
|
Member
Sehroosh
Join Date: Apr 2019
Location: Pakistan
Posts: 60
Rep Power: 7 |
In flow 3D, Analyze > Probe > Data Source: General History > Flux Surface Volume Flow Rate
Select Output type: Text or Graphical |
|
|
|
|
|
|
March 29, 2023, 13:30
|
|
#3 |
|
New Member
Eli
Join Date: Jul 2022
Location: Canada
Posts: 13
Rep Power: 4 |
thank you. I really appreciated your help
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh stuck when snap is turned on | yukuns | OpenFOAM Meshing & Mesh Conversion | 3 | February 2, 2021 14:05 |
| interFoam case mesh with baffles crushed | ves | OpenFOAM Running, Solving & CFD | 0 | December 16, 2020 16:08 |
| SimpleFoam & Theater | jipai | OpenFOAM Running, Solving & CFD | 3 | June 18, 2019 11:11 |
| [snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell | Arman_N | OpenFOAM Meshing & Mesh Conversion | 1 | May 20, 2019 18:16 |
| about modelling of baffles in Flow-3D | tecmia | FLOW-3D | 0 | September 24, 2012 10:27 |
Linear Mode
