Couple two launch results

mathioso · February 8, 2023, 03:55

Hi everybody,

Do you know if it's possible to couple two launch results, an initial from 0 to 80s, and a restart from 70 to 200s ? FLOW 3D v11

MSM1985 · February 9, 2023, 06:55

Just follow these steps:

i) Select first result file say "Main". Set your desired outputs and time frame. Check Option 'Render frames to disk', then RENDER

ii) Now open 2nd result file say "Restart". Again set your desired outputs and time frame. Check Options 'Render frames to disk' & 'Append to existing output". A dialog box will open. Go to the folder where you rendered the file "Main".

iii) When asked select "Overwrite All Files". Press RENDER.

Now you have results from both files in Display and shall play in sequence.

February 8, 2023, 03:55	Couple two launch results	#1
mathioso New Member Soulayrol Mathieu Join Date: Feb 2023 Posts: 1 Rep Power: 0	Hi everybody, Do you know if it's possible to couple two launch results, an initial from 0 to 80s, and a restart from 70 to 200s ? FLOW 3D v11

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The CoP Does not exist: Validating Aerodynamic forces through a "line of action"	ds4719	Main CFD Forum	14	February 18, 2022 19:05
Time sensitivity analysis - results variation	qntldoql	FLUENT	1	January 25, 2022 01:07
My results become inconsistent when using PIMPLE (nOuterCorrectors>1) instead of PISO	FloB	OpenFOAM Running, Solving & CFD	5	May 17, 2021 07:17
Validating the results of numerical modeling compared to the results of another model	ENG.AHMAD	FLUENT	0	June 22, 2020 17:49
bad heat transfer results with low y+	me45	OpenFOAM Running, Solving & CFD	0	April 29, 2020 12:56

February 9, 2023, 06:55		#2
MSM1985 Member Sehroosh Join Date: Apr 2019 Location: Pakistan Posts: 60 Rep Power: 7	Just follow these steps: i) Select first result file say "Main". Set your desired outputs and time frame. Check Option 'Render frames to disk', then RENDER ii) Now open 2nd result file say "Restart". Again set your desired outputs and time frame. Check Options 'Render frames to disk' & 'Append to existing output". A dialog box will open. Go to the folder where you rendered the file "Main". iii) When asked select "Overwrite All Files". Press RENDER. Now you have results from both files in Display and shall play in sequence.