How to run two FLOW-3D programs on one computer

Mike0515 · June 8, 2021, 11:08

Hello everyone, my computer has 64 CPU cores. I hope to run two programs on the same computer at the same time to speed up the calculation. I don't know if you have any experience in this area, thank you in advance.

Flow Science Australasia · June 8, 2021, 19:07

Hi Mike0515,

This will depend on your license file. Most standard licenses let you run a single model at a time. However, you can also get a license configuration that would let you run multiple models spread over your 64 cores.

I would suggest contacting the FLOW-3D representative in your region to discuss your options.

June 8, 2021, 11:08	How to run two FLOW-3D programs on one computer	#1
Mike0515 New Member Frankey Join Date: May 2021 Posts: 3 Rep Power: 5	Hello everyone, my computer has 64 CPU cores. I hope to run two programs on the same computer at the same time to speed up the calculation. I don't know if you have any experience in this area, thank you in advance.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Unable to run lid-driven cavity flow with 1M elements	dougalb	OpenFOAM Running, Solving & CFD	2	April 7, 2019 00:34
Run GA in local computer (linux)	Eleven Leo	CONVERGE	6	December 18, 2017 16:28
Re- 3.4x10^7- flow wont run properly	shafee	Main CFD Forum	12	March 25, 2016 19:05
fluid flow fundas	ram	Main CFD Forum	5	June 17, 2000 22:31
Flow visualization vs. Calculated flow patterns	Francisco Saldarriaga	Main CFD Forum	1	August 3, 1999 00:18

June 8, 2021, 19:07		#2
Flow Science Australasia New Member Eric Lemont Join Date: Aug 2020 Location: Brisbane, Australia Posts: 25 Rep Power: 6	Hi Mike0515, This will depend on your license file. Most standard licenses let you run a single model at a time. However, you can also get a license configuration that would let you run multiple models spread over your 64 cores. I would suggest contacting the FLOW-3D representative in your region to discuss your options.