|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
joey doherty
Join Date: Mar 2020
Posts: 1
Rep Power: 0 ![]() |
Hello All,
currently an Architecture student trying to simulation river flow and sediment flow in the st-lawrence river, canada. I have an stl of the bathemetry which I'm using as the geometry. - set up the global settings to simulate for 2 hours (7200s) - physics include: shallow water model, gravity, viscosity, particles - geometry is an imported stl - i have it set up exactly in the same way as the shallow water model example from flow3d - mesh was created with the shallow water model checked off. cells at 100m - initial water is hydrostatic and set at appropriate water level. I keep getting errors on my mesh not being set up appropriately. see attachments for screen shots thanks for your help! joey ![]() |
|
![]() |
![]() |
![]() |
Tags |
meshing, sediment, shallow water model, stl, water level |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[IHFOAM] The IHFOAM Thread | Phicau | OpenFOAM Community Contributions | 392 | September 8, 2023 18:10 |
interFoam wave propagation and explosion of Courant number and residuals | ChiaraViola | OpenFOAM Running, Solving & CFD | 1 | June 26, 2019 05:36 |
Simulation multiphase airlift reactor with Eulerian multiphase model question???? | dilok.kumyoo | FLUENT | 0 | January 28, 2015 02:15 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Water vapour condensation in CFX-5.7.1 | hdj | CFX | 1 | November 27, 2005 07:15 |