FLOW 3D Layers deposition

Kasani Tirupataiah · December 5, 2019, 06:13

Hello Everyone

FLOW 3D V9.3: In welding simulation for two layer one over the other first layer deposited but during the deposition of the second layer weld pool formed is moving completely along along with arc (in the length direction) without any material deposition over the first layer so that at the end of simulation time the formed weld pool is moving to the end position but without any material deposition left over the first layer during travel.

What are the reasons for this condition in flow 3D?
how can i overcome this?

Please guide/suggest me with proper useful information to solve this...

Thanking you in ADVANCE.

thunde47 · March 2, 2020, 16:26

This should not happen. Likely some mistakes made in the simulation setup. can you post the image, please?

December 5, 2019, 06:13	FLOW 3D Layers deposition	#1
Kasani Tirupataiah New Member tirupataiah Join Date: Dec 2019 Posts: 1 Rep Power: 0	Hello Everyone FLOW 3D V9.3: In welding simulation for two layer one over the other first layer deposited but during the deposition of the second layer weld pool formed is moving completely along along with arc (in the length direction) without any material deposition over the first layer so that at the end of simulation time the formed weld pool is moving to the end position but without any material deposition left over the first layer during travel. What are the reasons for this condition in flow 3D? how can i overcome this? Please guide/suggest me with proper useful information to solve this... Thanking you in ADVANCE. Last edited by Kasani Tirupataiah; December 11, 2019 at 01:47.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Internal Flow Instability with layers	Zephiro88	OpenFOAM Running, Solving & CFD	1	June 20, 2019 05:20
Gate valve flow simulations...	nikesh	FloEFD, FloWorks & FloTHERM	5	January 28, 2014 02:31
transient, impregnating flow problem	fgommer	FLUENT	0	February 29, 2012 17:10
Non-steady flow simplified for use in Vissim	steamerandy	Main CFD Forum	0	October 31, 2011 22:08
Boundary layers in supersonic flow	bob Will	Main CFD Forum	4	April 24, 2000 00:19

March 2, 2020, 16:26		#2
thunde47 Senior Member thunde47 Join Date: Dec 2015 Location: India, USA Posts: 133 Blog Entries: 1 Rep Power: 11	This should not happen. Likely some mistakes made in the simulation setup. can you post the image, please?