|
[Sponsors] |
August 3, 2018, 09:11 |
problems when using sediment scour model
|
#1 |
New Member
mengchen
Join Date: Apr 2018
Posts: 1
Rep Power: 0 |
hello everyone !
i am using Flow 3D V11.2 to simulate local scour around a cylinder , however when I compare my results with experiment results,the simulation maximum scour depth and the equilibrium time are much smaller than the experiment results. I have tried a lot of methods to get the right results, but they all failed. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
scour sediment model | javadrasooli | FLOW-3D | 2 | May 15, 2015 13:23 |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 06:36 |
sediment scour model, scalars OR mass particles? | ati_ros61 | FLOW-3D | 2 | November 17, 2013 12:17 |
Problems when using Population balance model with Boiling model | luliqiang | FLUENT | 0 | May 28, 2013 06:22 |
Turbine Analysis - Alternate Rotation Model and Meshing Problems | sean89dunn | CFX | 2 | March 23, 2013 23:27 |