 |
 |
 |
|
|
|
[Sponsors] | ||||
May 16, 2018, 06:26
|
Boundary layer
|
#1 |
|
New Member
Ehsan
Join Date: May 2017
Posts: 4
Rep Power: 9  |
Dear
I am simulating the hydraulic structure. near the wall, i decreased the cell size but the model didn't recognize the boundary layer?? |
|
|
|
|
|
May 17, 2018, 19:28
|
Boundary Layer
|
#2 |
|
New Member
Join Date: Jan 2017
Posts: 5
Rep Power: 9 |
Hi
It's maybe due to y+ value. I think that the size of the cells close to the wall, should be modified so that the value of y + is between 30 and 100. Refer to FLOW-3D manual (version 11.1)--->Model Reference--->Wall Shear Hope you success |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 18:38 |
| Centrifugal fan-reverse flow in outlet lesds to a mass in flow field | xiexing | CFX | 3 | March 29, 2017 11:00 |
| Any formula for approximating the boundary layer thickness around a cylinder? | bestniaz | Main CFD Forum | 0 | October 24, 2015 03:00 |
| [ICEM] 3D Dynamic Mesh - Boundary layer mesh issues | nathanricks | ANSYS Meshing & Geometry | 0 | September 23, 2015 06:14 |
| Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 01:00 |
Linear Mode
